Arietta KIT01935 Manuel d'instructions télécharger pdf (Page 3)

INSTALLATION INSTRUCTIONS

1) Uninstall the fixed duct cover (if present), duct cover bracket, air deflectors (if present) and ductworks, in

accordance with the hood manual.

2) Find the centerline of the cook top. Use a level to draw a vertical straight pencil line on the wall.

CHECK TO BE SURE THE LINE IS PERFECTLY PERPENDICULAR TO THE HORIZONTAL COOKING

SURFACE.

Note: The duct bracket should be installed against the back wall and flush with the ceiling. This bracket will hold the

duct cover in place at the top.

Make sure of using the right type of screws and/or fasteners, depending of the material of your wall.

3) Secure the bracket to the wall:

• Align the marked centerline on the bracket with the centerline on the wall.

• Mark 2 hole locations for the screws in the wall.

• Drill 5/16" pilot holes in the marked locations.

• Install wall fastener anchors.

• Drive the bracket screws (provided with the hood) slowly, into the fasteners to allow anchors to expand.

• Remove the screws.

• Secure the bracket to the wall with the bracket screws (provided with the hood).

4) Reinstall the air deflectors (if present) and ductworks, in accordance with the hood manual.

5) Mounting the duct cover

• Position the duct cover over the mounted hood, sliding the bottom of the duct cover into the assigned area.

• Grab the upper part of the telescopic duct cover, pull it up, and place it in the duct cover mounting bracket.

• Secure the top of the duct cover with 2 assembly screws (provided with the hood).

• Secure the bottom of the duct cover with 2 assembly screws (provided with the hood).

1 2 3 4 5

Pas de commentaire

Arietta KIT01935 Manuel d'instructions Page 3